Because there are several version of the same items, please take noted the very first step is to find the label on the pan-tilt about the correct operating voltage, any in-appropriate power supply will likely damage the circuit and void the warranty.
The connection is simple, you suggest opening the lower cover of housing. Identify the DIP switch panels from the board.
There are several groups of switches.
From left to right:
#1-#6: ID addressing
#7-#8: baud rate
#1-#4: Protocols
You just need to connect two things.
1) The AC power input of correct voltage
2) RS 485 control cables to your controlling device. e.g. DVR.
Steps:
1) choose the protocol and ID, baud rate
2) connecting the camera
3) connect RS485
4) connect 24V AC power of the pan-tilt
That's all.
Quick Starter Guide for CCTV Pan-Tilt Q Series
Who is online
Users browsing this forum: No registered users and 6 guests