CXG4D: How configure the sms or call to phone when alarm
Posted: Fri Feb 26, 2010 9:33 am
Assuming the panel has been ready.
Make sure:
1) antenna fixed
2) power connected
3) at least one sensor (e.g. door contact or motion detector) has been learnt
4) the STATUS LED on the front panel is GREEN or flashing GREEN that means correct SIM card has been inserted and GSM network signal is detected
Now use another phone, prepare this SMS message
123456#10#12345678901#
send it to the phone number of the SIM card inside the alarm panel
you must be able to see the STATUS LED flashing RED for a while, that means SMS received
Now it should be ready to send alert by calling the no. 12345678901 defined above.
Remark:
1) 123456 above is the password
2) 10 following the first phone number to send SMS, 11 the 2nd and so forth.
3) If you want to make phone calling instead of SMS, start remark (2) above with 15. So 15 is the 1st phone number to call, 16 the 2nd, and so forth.
Make sure:
1) antenna fixed
2) power connected
3) at least one sensor (e.g. door contact or motion detector) has been learnt
4) the STATUS LED on the front panel is GREEN or flashing GREEN that means correct SIM card has been inserted and GSM network signal is detected
Now use another phone, prepare this SMS message
123456#10#12345678901#
send it to the phone number of the SIM card inside the alarm panel
you must be able to see the STATUS LED flashing RED for a while, that means SMS received
Now it should be ready to send alert by calling the no. 12345678901 defined above.
Remark:
1) 123456 above is the password
2) 10 following the first phone number to send SMS, 11 the 2nd and so forth.
3) If you want to make phone calling instead of SMS, start remark (2) above with 15. So 15 is the 1st phone number to call, 16 the 2nd, and so forth.